Preparation; Instructions For Batteries; Checking The Charge Status Of The Battery - Parkside PBSA 20-Li A1 Translation Of The Original Instructions

GB
Ensure that the mains
•
voltage matches the
specifications on the
charger rating plate. Risk
of electric shock.
Keep the charger clean
•
and away from wet
and rain. Do not use
the charger outdoors.
Dirt and the entry of water
increase the risk of electric
shock.
Avoid mechanical dam-
•
age to the charger. This
can result in internal short cir-
cuits.
The charger must not
•
be operated on or near
flammable surfaces
(e.g. paper, textiles). Risk
of fire due to heating caused
by charging.
If the mains connection cable
•
of this device is damaged, it
must be replaced by the man-
ufacturer, their customer ser-
vice or by a similarly quali-
fied person in order to avoid
hazards. contact the service
centre.
Pull the mains plug when the
•
battery is fully charged and
disconnect the battery from
the charger.
22
Do not use the charger to
•
charge non-rechargeable bat-
teries.

Preparation

WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.

Instructions for Batteries

WARNING! Risk of injury from leak-
ing electrolyte solution! Do not expose
the battery to extreme conditions such as
heat or impact. In case of eye or skin con-
tact, rinse the affected areas with water or
neutraliser and seek medical attention.
• Switch off the device and remove the
battery before carrying out any main-
tenance work.
• The rechargeable battery only reaches
its full capacity once it has been
charged several times.
• Charge the battery before the first time
of use.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery of the series X 20 V TEAM,
available from our Online-Shop
(www.grizzlytools.shop).
• Always take heed of the applicable
safety instructions as well as the envir-
onmental protection regulations and in-
formation.
Checking the charge status
of the battery
1.
Press the charge level indicator
button (2) on the battery (3).