Setting The Tam Interface Mode; Operation Of Tam Interface Mode - Panasonic Panafax UF-585 User Manual

Receiving Documents

Setting the TAM Interface Mode

1
Change Fax Parameter No. 16 (OUT MODE) to 2 : TAM I/F. (See page 37)
2
OUT
Confirm that the display is as shown to the right.

Operation of TAM Interface Mode

1
When your TAM and Fax receives an incoming call, the TAM always answers the call
first and then the TAM plays the OGM (Outgoing Message) recorded in your TAM to
the calling station. During the time the TAM is answering the call, your fax machine will
be monitoring the line to distinguish whether it is a voice or fax call.
If it is a Fax call,
2a
Your machine will switch the line to the
fax and then begin to receive the
documents immediately from the
calling station.
Sample of OGM
Hello, this is Smith. Sorry I am unable to take your call. Please leave your message after the beep or if
you are calling to send a fax, press the asterisk button twice on your touch tone phone now and start
your machine. Thank you for calling.
Silent Detection Mode
Enables your Fax machine to switch to the Fax Mode when receiving from units that do not send fax
signal (short beep) and prevents your TAM from recording blank (long silence) incoming message.
To activate this feature,
1. Change Fax Parameter No. 20 (SILENT DET.) to 2 : Valid. (See page 38)
2. Set the time length of the OGM recorded in your TAM with the Fax Parameter No. 19 (OGM
LENGTH). (See page 38.)
[We recommend to set the time length 5 or 6 seconds longer than the actual time length of the OGM.]
66
MAR-12-1999 15:00
RCV MODE=FAX/TAM 00%
If it is a Voice call,
2b
Your TAM continues to record a message
(ICM) after playing the OGM.