Led Indicators - Planet WRT-403 User Manual

If the connection cannot be established (LAN LED is not
ë Note
on), please connect to the Uplink port instead, and check
if the supplied cable is broken.
Reset Button This button has two (2) functions:
Reboot. When pressed and released, the router will reboot (restart).
Clear All Data. This button can also be used to clear ALL data and
To Reboot machine without Clearing Existing Configurations:
To Clear All Data and restore the factory default values:
These steps can restore machine factory default IP
ë Note
address: 192.168.0.1, and User name / Password to
"admin".
Power port Connect the supplied power adapter here.
ANT The reversed-polarity SMA connector for wireless antenna. Please find
the omni-antenna from the package.

2.2 LED Indicators

Wireless Broadband Router
WRT-403
LED STATE
Green
PWR
Off
Blinking
WLAN
Off
Orange
10/100
Off
Green
LNK/ACT Blinking Green
Off
restore ALL settings to the factory default values.
Press the reset button with a pencil tip (for less than 4 seconds),
machine will re-boot itself, the existing configurations will be kept.
Press the reset button for longer than 4 seconds and the router will
reset itself to the factory default settings (warning: your original
configurations will be replaced with the factory default settings)
MEANING
Device power on
Device power off
WLAN activity
On wireless device connected
Port works on 100Mbps
Port works on 10Mbps
Link is established
Packets are transmitting or receiving
Not connected
- 4 -
WAN LAN
10/100
LNK/
ACT
PWR WLAN 1 2 3 4