Drive Axle, Inserted Inner Joint, Servicing - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
1 - Nut
❑ 500 Nm
❑ Always replace if re‐
moved.
❑ Before assembling, coat
contact surface with As‐
sembly Paste .
2 - Outer CV Joint
❑ Replace only as com‐
plete unit.
❑ Removing and Instal‐
ling, refer to
⇒ "7.9 Drive Axle, Inser‐
ted Inner Joint, Servic‐
ing", page 194 .
❑ Before assembling, coat
splines with Assembly
Paste .
3 - Clamp
❑ Always replace if re‐
moved.
❑ Tensioning, refer to
⇒ "7.10 Small and Large
Clamps, Tightening on
Inner or Outer Joint",
page 195 .
4 - CV Boot
❑ Check for tears and
scuffing.
5 - Clamp
❑ Always replace if re‐
moved.
❑ Tensioning, refer to
⇒ "7.10 Small and Large
Clamps, Tightening on Inner or Outer Joint", page 195
6 - Locking Ring
❑ Always replace if removed.
❑ Insert in shaft groove.
7 - Drive Axle
8 - CV Boot
❑ Check for tears and scuffing.
9 - Inner CV Joint
❑ Replace only as complete unit.
❑ Removing and Installing, refer to
10 - Locking Ring
❑ Always replace if removed.
❑ Insert in shaft groove.
7.9 Drive Axle, Inserted Inner Joint, Servic‐
ing
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
194
Rep. Gr.42 - Rear Suspension
⇒ "7.9 Drive Axle, Inserted Inner Joint, Servicing", page 194
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
.