Casio CASSIOPEIA EG-800 Service Manual And Parts List page 18

Hide thumbs Also See for CASSIOPEIA EG-800:
Table of Contents

Advertisement

1. Make sure your CASSIOPEIA is turned off.
• Press the [Power] button to turn off power.
2. Remove the card slot cover from the CASSIOPEIA.
• Slide the card release to the Free position.
3. If there is already a card in the slot, use the stylus to pres the EJECT button straight down, and
remove the card.
4. Slide the card you want to use into the card slot.
• Make sure the top of the card is facing towards the top of the CASSIOPEIA unit. A card that is not
oriented correctly will not slide all the way into the slot.
Carefully slide the card into the slot as far as it will go.
5. Re-attach the card slot cover to the CASSIOPEIA.
• If you are using a digital camera card or another type of card equipped with a lock, slide the card
lock to the LOCK setting to secure the card in place.
Infrared Communications
The infrared port of this unit can be used to exchange data with another CASSIOPEIA, or with another
device equipped with infrared communication capabilities. Remember that the two infrared ports must
be pointed directly at each other when performing communications. The distance between the two infrared
ports must be less than 30 cm.
See the Pocket PC User's Guide for full details on performing infrared communications.
For infrared data communications with another device, the other device must conform with IrDA 1.1
standards, and it must specifically support infrared data communication with a CASSIOPEIA.
Important
• Take care so either of the units does not move while infrared data communications are in progress.
• Infrared data communications may be impossible under strong sunlight or inverter type fluorescent
lighting.
• Infrared data communication problems can be caused by the distance between the two ports, the
angle between the two ports, outdoor sunlight, and low batteries.
• Dirt and dust on the infrared port surface can cause communications errors and other problems.
Use a soft, dry cloth to wipe the port clean of dirt and dust.
EJECT button
Top
Bottom
— 15 —

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jx-590a

Table of Contents