Skoda Octavia IV 2020 Service Manual page 180

Octavia IV 2020 ➤, Octavia IV 2021 ➤
Maintenance - Edition 12.2020
The vehicle must have rolled a few metres or have been de‐
pressed a few times at the front and rear to allow the springs to
settle.
Inclination value:
• Basic setting for the inclination value adjustment: -1%
Caution
The inclination value is marked on the top of the headlight
housing. The headlights must be set to this value.
The inclination value in "%" does not have a minus symbol.
The percentage value applies up to 10 metres projection
distance. This will be 10 cm for an inclination value of e.g. 1
%.
6.12.2 Adjusting the LED headlights
Special tools and workshop equipment required
♦ Headlight beam setting device
Inclination value:
• Basic setting for the inclination value adjustment: -1%
Caution
The headlight setting change is a repair measure.
Headlight adjustment is charged separately.
Use a headlight beam setting device for setting the headlight
beam. Nominal values and conditions
conditions", page 173
Check setting
– Switch on low beam light.
– Set the headlight to the basic position in the vehicle's Info‐
tainment system ⇒ Owner's Manual.
– Check whether the light beam generates the light-dark limit
on the dividing line -2- of the control surface when the low
beam is switched on.
If a deviation is determined during the adjustment check, a
headlight adjustment must be carried out as follows:
174
6. Electrical System
⇒ a6.12.1 nd setting
.