Operating
Instructions
Warning:
Always wear safety glasses when operating hand tool.
Instructions:
1. Turn tension adjustment knob until
desired tension setting is displayed in
tension
indicator
between numbers counts as one-half
setting. See step 6.
2. Extend handle open to release gripping
mechanism and insert clamp tail into tool
through front load entry.
3. Squeeze handle repeatedly to tighten
band around object. Be sure to release
handle completely to use full pull-up
stroke of tool. Buckle must be secure
against the tool head and nestled
between the two retention clips. Once
the preset tension has been reached, the
handle will no longer release completely.
4. To cut-off excess clamp tail, squeeze
handle one last time.
5. The tool must be reset by, extending the
handle out until it snaps into place, the
tool will be ready to apply the next
clamp.
6. Tension Setting Range:
.250 Smooth I.D. Tie-Lok
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
window.
Space
0 – 8
www.BAND-IT-IDEX.com
Page 1 of 4
Tie-Lok II Tool
Tension
Adjustment
Knob
Document # A92051 rev. H
BAND-IT-IDEX, Inc. 2006
A92079
Tension Indicator
Window
Handle
© Copyright
All rights reserved