Band-it S03869 Operating Manual

Operating
Manual
1. Tool is designed specifically for 3/8" and 5/8"
center punch clamps only. Insert clamp in tool and
then insert wrench assembly. If you prefer, install
wrench assembly before clamp is inserted. Slot must
be aligned with clamp tail.
3. Place punch on clamp and while holding
tension with ratchet wrench, lock clamp by striking
punch once or more with hammer, depending on
object being clamped.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
5. To loosen clamp tail, wind ratchet wrench until
tail is free. Remove ratchet wrench assembly and
clamp tail. Caution: Clamp tail may spring back
once released from tool nose.
www.BAND-IT-IDEX.com
Page 1 of 2
S03869 - BAND-IT
Center Punch Tool
2. Start "pumping" ratchet wrench forward until proper
tension has been applied.
4. While holding tension with wrench, pivot tool up
against buckle, then backward several times to
break off clamp tail.
Document # PO6788 rev. D
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved