Before Using The Appliance; Putting Into Operation; Insert The Batteries In The Remote Control; Setting The Weekday And The Time - Profi Care PC-BSR 3108 Instruction Manual

to sleep mode. If you continue to hold the appliance in
your hand, the appliance will beep again at regular in-
tervals. When you place the appliance back on the floor,
you will hear a beep.
• Due to the design, cleaning carpets and driving over
edges is only possible to a limited extent. Short pile
carpets with low edges can be driven over. For long-pile
carpets, please use a conventional 230 V floor hoover.
• The sensors on the underside of the appliance detect
steps or other depressions so that the appliance cannot
fall down.
CAUTION:
Before each use, make sure that the sensors are
clean, otherwise the appliance may fall.
Nevertheless, depending on the nature of the stair tread
(colouring, construction, etc.), the sensors may not be
able to detect the landing. Do not leave the appliance
unattended, especially near the stairs.

Before Using the Appliance

• Clear the floor of any objects lying around that could
obstruct the side brushes or get caught in the nozzle or
stop the appliance from cleaning.
• Remove all objects that could be knocked over (e. g.
vases, small lamps, decorative items, etc.).
• Make sure that no cables, cords or fringes, e. g. from
curtains, tablecloths or carpets, are accessible to the
appliance. If necessary, fold the edges of carpets with
fringes under the carpet. The appliance could otherwise
get caught in them.

Putting Into Operation

Insert the Batteries in the Remote Control

(Batteries are not included in the scope of delivery)
1. Open the battery compartment cover on the back of the
remote control.
2. Insert 2 AAA / R03 1.5 V batteries. Make sure the polarity
is correct (see battery compartment bottom)!
3. Close the battery compartment cover.
4. The display of the remote control shows the weekday
(SUN), the time ( ) and the symbol for the suction
power ( ).

Setting the Weekday and the Time

To set the weekday and the time in the remote control,
proceed as follows:
1. Press the button. The clock symbol appears in the
display and the weekday starts flashing.
2. Select the current weekday with the
SUN = Sunday
MON = Monday
TUE = Tuesday
WED = Wednesday
16
PC-BSR3108_IM
/ buttons.
THU = Thursday
FRI = Friday
SAT = Saturday
3. Confirm your selection with the
changes to the hour entry.
4. Now set the hour with the
change to the minute input with the
5. Also set the minutes with the
6. Confirm your entry with the
If you do not press any button within approx. 14 seconds,
the setting will be discarded.

Setting Up the Charging Station

1. Place the charging station on a wall. Make sure that
there is a power socket nearby.
- Place the cable from the power supply unit so that the
appliance cannot get caught in it.
2. Make sure that there are no objects 2 m in front of and
1 m to the right and left of the charging station. These
could obstruct the appliance when searching for the
charging station.
3. Plug the connector from the power supply unit into the
socket on the charging station.
4. Plug the power supply unit into a properly installed
earthed socket. The control lamp of the charging station
lights up.

Charging the Rechargeable Battery

Before you can use the appliance, you must first charge the
built-in rechargeable battery. Always charge the appliance
without the water tank installed.
1) Place the appliance with the charging surfaces on the
charging contacts of the charging station. The control
lamps in the buttons on the appliance pulsate.
or
2) Press the button on the remote control or on
the appliance. The appliance starts searching for the
charging station. This may take a little longer the first
time. Both control lamps on the appliance flash. As soon
as the appliance has docked at the charging station, the
control lamps in the buttons on the appliance pulse.
• When the rechargeable battery is fully charged, you will
hear a beep and the control lamps in the buttons on the
appliance will go out.
• Charge the appliance for at least 12 hours before using it
for the first time.
- When the rechargeable battery is exhausted, the
appliance automatically starts searching for the
charging station. Both control lamps on the appliance
flash. As soon as the appliance has docked at the
charging station, the control lamps in the buttons on
the appliance pulse.
- Even when the unit is switched off, the rechargeable
battery is constantly discharging. If you do not use
the appliance for a longer period of time, charge the
rechargeable battery at least every 4 to 6 weeks.
button. The selection
/ buttons and then
button.
/ buttons.
button.
17.04.23