Daewoo DCS2512 User Manual page 4

5. Eliminate all sources of sparks or flame (i.e. smoking, open flames, or
work that can cause sparks) in the areas where fuel is mixed, poured,
or stored.
6. Do not smoke while handling fuel or while operating the chain saw.
7. Do not allow other persons to be near the chain saw when starting or cutting.
Keep bystanders and animals out of the work area. Children,
pets and bystanders should be a minimum of 10 m away when
you start or operate the chain saw.
8. Never start cutting until you have a clear work area, secure footing,
and a planned retreat path from the falling tree.
9. Always hold the chain saw firmly with both hands when
the engine is running. Use a firm grip with thumb and
fingers encircling the chain saw handles.
10. Keep all parts of your body away from the saw chain
when the engine is running.
11. Before you start the engine, make sure the saw chain is not
contacting anything.
12. Always carry the chain saw with the engine stopped, the guide bar and
saw chain to the rear, and the muffler away from your body.
13. Always inspect the chain saw before each use for worn, Ioose, or damaged
parts. Never operate a chain saw that is damaged, improperly
adjusted, or is not completely and securely assembled. Be sure that the saw
chain stops moving when the throttle control trigger is released.
14. All chain saw service, other than the items listed in the Owner's Manual,
should be performed by competent chain saw service personnel. (E.g.,
if improper tools are used to remove the flywheel, or if an improper tool is
used to hold the flywheel in order to remove the clutch, structural damage
to the flywheel could occur which could subsequently cause the flywheel
to disintegrate.)
15. Always shut off the engine before
setting it down.
3