Adjusting The Carburetor - Daewoo DCS2512 User Manual

pulled out, it will not return to the operating position even if you press down on it with your finger.
When you wish to return the choke knob to the operating position, pull out the throttle lever instead.
5. While holding the saw unit securely on the ground, pull the starter rope vigorously.
WARNING
Do not start the engine while the chain saw hangs in one hand. The saw chain may touch your body.
This in very dangerous.
6. When engine has ignited, first push in the choke knob to the first-stage position and then pull the
starter again to start the engine.
7. Allow the engine to warm up with the throttle lever pulled slightly.
CHECKINGTHE OIL SUPPLY
WARNING
Make sure to set up the bar and the chain when checking the oil supply. If not, the rotating parts
may be exposed. It is very dangerous.
After starting the engine, run the chain at medium speed and see if
chain oil is scattered off as shown in the figure.
The chain oil flow can be changed by inserting a screwdriver
in the hole on bottom of the clutch side. Adjust according to
your work conditions.
The oil tank should become nearly empty by the time fuel
is used up. Be sure to refill the oil tank every time when
refueling the saw.
ADJUSTINGTHE CARBURETOR
The carburetor on your unit has been factory adjusted, but may require fine tuning due to a change
in operating conditions.
Before adjusting the carburetor, make sure that the provided air/fuel filters are clean and fresh and
the fuel properly mixed.
When adjusting, take the following steps:
NOTE
Be sure to adjust the carburetor with the bar chain attached.
13