Veco Climma Compact 5 Installation Manual Use & Schematics page 5

CONDITIONING PLANTS
2.1 - CABIN CONDITIONER: HOW IT WORKS
When in cool mode ( ummer) the refrigerant circuit takes the
heat from the ambient air and gives it to the sea water. When
in heat mode (winter) the heat is taken from the sea water
which cools down and it is given to the ambient air which
warms up. With sea water below 10° C, the efficiency of the
unit in heat mode drops so much that we do advise against its
use. Units with electrical heating instead of reverse cycle are also available.
Cool and heat position, thermostat knob for temperature setting and fan
selector are available on the control panel which shall be installed in the air-
conditioned ambient at a max distance of 3 m from the evaporator.
2.2 - LOCATION
A.- The unit is engineered to draw directly the ambi-
ent air, then the unit should be installed in one of the
cabins to be conditioned (only the evaporator assy in
case of Split models).
M I N
C.- Treating the ambient air means the separation of
condensate produced by air humidity. His conden-
sate must be drained and discharged over board; this
means that the unit should be installed at a certain
level to be connected to an outlet port, considering
that the condensate hose must have a minimum
heeling.
page 4
SPLIT and COMPACT models
2 COMPONENTS INSTALLATION
B.- The treated air (blown by the fan) should be con-
nected to one or more delivery grills by means of flex-
ible ducts or using a yacht structure as a duct. Duct
must be properly insulated.
MAX
3 mt
www.climma.it