Remote Panel - Veco Climma Compact 5 Installation Manual Use & Schematics

CONDITIONING PLANTS

2.11- REMOTE PANEL

The control panel has the following functions:
2.11.A - LOCATION
When positioning the panel, one must consider that the
panel should be connected to the electrical box with the 3
m long cable and the thermostat bulb should be fastened
to the unit. If necessary, the bulb can be installed not
directly on the exchanger, but in the room. Anyway, it must
sense the ambient temperature. The bulb can be fixed
using the plastic plate supplied with it.
2.11.B.- INTERCHEANGEBLE BEZEL
The bezel supplied with the panel is black.
2.11.C - INSTALLATION
The panel is for flush installation and needs a cut out as
shown here on the right:
WARNING:
when installed the back side of the panel, shall not be normally accessible. A plastic
cover is available on request in order to protect the back of the panel if accessible,
therefore dangerous.
page 9
SPLIT and COMPACT models
2 COMPONENTS INSTALLATION
The panel is connected to mains supply. It is absolutely necessary that,
A.- Start and stop
CONDIZIONAMENTO ESTIVO : premendo il tasto
SUMMER COOLING: Pushing the "COOL" button with ice
star mark.
WINTER HEATING: Pushing the "HEAT" button with
orange sun mark.
To stop the unit you must push the buttons "COOL" and
"HEAT" together.
B.- Setting of room temperature by thermostat
(TEMP).The thermostat has a 3 m long capillary with a
bulb, which must feel the return air (it must not touch the
evaporator fins).
C.- Adjusting the fan speed ( 3 speeds available )
Important: the low speed is selected pushing the two but-
tons "Max" and "Med" together.
www.climma.it