Control Panel - Veco Climma Compact 5 Installation Manual Use & Schematics

CONDITIONING PLANTS

6.1.- CONTROL PANEL

COOL: "COOL" mode switch
HEAT: "HEAT" mode switch
FAN: Fan speed change over switch
TEMP: Room thermostat knob
6.2.- COOLING MODE (SUMMER)
Run the unit pushing the "COOL" button. Turn the thermostat knob anticlockwise towards "18" until the com-
pressor starts. Set the "FAN" switch on the desired speed "MIN-MAX". The minimum speed is obtained by
pushing the two knobs Max and Min together.
When the cabin reaches the desired temperature, turn clockwise the thermostat knob towards "24" until the
compressor stops. As the compressor goes off, the fan will circulate the air without cooling it until the com-
pressor will start again.
6.3.A.- HEATING MODE (WITH REVERSE CYCLE HEATING - MOD. RC)
Run the unit pushing the "HEAT" button. Turn the thermostat knob clockwise towards "24" until the com-
pressor starts. Let the unit run until the room reaches the desired temperature, then turn the thermostat
knob counter clockwise towards "18" until the compressor goes off. As said at 6.2, the fan will circulate the
air without heating it. In heating mode, the fan speed should be always set on MAX or MIN speed, as the
low speed can cause a cut out of the compressor due to high pressure.
6.3.B.- HEATING MODE (WITH ELECTRICAL HEATING - MOD. EH)
Run the unit pushing the "HEAT" button. Turn the thermostat knob clockwise towards "24". Let the unit run
until the room reaches the desired temperature, then turn the thermostat knob counter clockwise towards
"18" until the heating element goes off. As said at 6.2, the fan will circulate the air without heating it. If there
is a failure of the fan or the air circulation is clogged or obstructed, an internal safety klaxon cuts the ele-
ment off to prevent overheating. In order to reset the normal functioning, it is necessary to stop the system,
eliminating the reason of the lack of air circulation, wait approximately 5 minutes and then restart the sys-
tem pushing the "HEAT" button on the control panel. In "Heat" mode the compressor and the pump will not
run with electrical heating.
page 24
SPLIT and COMPACT models
6 USE
www.climma.it