Seneca Z-LINK2-LO User Manual page 5

USER MANUAL - Z-LINK2-LO
1. INTRODUCTION
The Z-LINK2-LO device is designed to transparently transfer serial packets over a wireless network.
The simplified outline of Z-LINK2-LO is:
The Z-LINK2-LO USB port can only be used for programming Z-LINK2-LO from a Windows™ PC with the Easy
Setup software.
For the connection with Modbus RTU devices it is possible to use the RS232 or RS485 port.
The radio connects two or more Z-LINK2-LO devices.
Two working modes are supported: "Bridge Mode" and "Remote I/O Mode".
It is also possible to configure a device as a radio signal repeater.
5