Advertisement
PRELIMINARY WARNINGS
The word WARNING preceded by the symbol
The word ATTENTION preceded by the symbol
instrument or the connected equipment. The warranty shall become null and void in the event of improper use or
tampering with the module or devices supplied by the manufacturer as necessary for its correct operation, and if
the instructions contained in this manual are not followed.
WARNING: The full content of this manual must be read before any operation. The module must only be used by
qualified electricians. Specific documentation is available via QR-CODE shown on page 1.
Electrical and electronic waste disposal (applicable in the European Union and other countries with recycling).
The symbol on the product or its packaging shows the product must be surrendered to a collection centre
authorized to recycle electrical and electronic waste.
SENECA s.r.l.; Via Austria, 26 – 35127 – PADOVA – ITALY; Tel. +39.049.8705359 - Fax +39.049.8706287
CONTACT INFORMATION
Technical support
This document is the property of SENECA srl. Copies and reproduction are prohibited unless authorised.
The content of this document corresponds to the described products and technologies.
Stated data may be modified or supplemented for technical and/or sales purposes.
MI00602-1-EN
INSTALLATION MANUAL
Z-LINK2-LO
The module must be repaired and damaged parts replaced by the Manufacturer. The product is sensitive to
electrostatic discharges. Take appropriate measures during any operation.
support@seneca.it
INSTALLATION MANUAL
indicates conditions or actions that put the user's safety at risk.
indicates conditions or actions that might damage the
DOCUMENTATION
Z-LINK2-LO
Product information
sales@seneca.it
1/4
Advertisement
Table of Contents
Related Manuals for Seneca Z-LINK2-LO
Summary of Contents for Seneca Z-LINK2-LO
- Page 1 The symbol on the product or its packaging shows the product must be surrendered to a collection centre authorized to recycle electrical and electronic waste. DOCUMENTATION Z-LINK2-LO SENECA s.r.l.; Via Austria, 26 – 35127 – PADOVA – ITALY; Tel. +39.049.8705359 - Fax +39.049.8706287 CONTACT INFORMATION Technical support support@seneca.it Product information sales@seneca.it...
- Page 2 MODULE LAYOUT 17.5 mm Dimensions LxHxD: 17.5 x 102.5 x 111 mm; Weight: 110 g; Enclosure: PA6, black SIGNALS VIA LED ON FRONT PANEL STATUS LED meaning Flashing Packet transmission on the bus Flashing Packet transmission on radio module ---- Not used Flashing Module powered correctly...
- Page 3 Communication parameters from EEPRON (default: 38400 baud - 8N1) N.B.: any change must be performed only using the Easy Setup 2 software The radio module is internally connected to IDC10 (Seneca RS485 bus) and to terminals 7-8-9 Programming mode with Easy Setup...
- Page 4 N.B.: the indication of the RS485 connection polarity is not standardised and in some devices may be inverted. Power supply and Modbus interface are available using the Seneca DIN rail bus, via the IDC10 rear connector, or the Z-PC-DINAL2 accessory.
Need help?
Do you have a question about the Z-LINK2-LO and is the answer not in the manual?
Questions and answers