D I S T R I B U T E D V A L V E S TABLE OF CONTENTS ® WHEATLEY SERIES 822/820 CHECK VALVE Description ................... 3 Installation & Operation ................ 5 Maintenance..................6 Maintenance Schedule................7 Recommended Spare Parts.
D I S T R I B U T E D V A L V E S DESCRIPTION The Wheatley 822/820 swing check valve features a hinged stainless steel clapper with a lip type seal. The design allows the clapper to swing freely from the closed position to the fully opened position and back. The cover is threaded to the body and sealed with an O-ring.
Page 4
D I S T R I B U T E D V A L V E S If the valve, in service, is exposed to hazards such as excessive piping system reaction forces and movements, contact the factory, to confirm that the valve design is suitable for the application.
D I S T R I B U T E D V A L V E S INSTALLATION & OPERATION NOTE: If system hydrostatic tests are to be performed at pressures exceeding the rated working pressure of the valve, the valve should be pressurized from the upstream side. This prevents exposure of the clapper to these pressures while the body cavity can accept up to 150% rated working pressure.
D I S T R I B U T E D V A L V E S MAINTENANCE CAUTION: Safety practices for pressurized equipment must be followed and address hazards inherent in pressurized systems. Extreme caution and safety procedures are to be exercised whenever valves, or fittings on a valve, are serviced or maintained.
D I S T R I B U T E D V A L V E S Figure 1: BODY / COVER MATERIAL DUCTILE IRON WCC, LCC, CF8M, ALUMINUM BRONZE SIZE TORQUE FT-LBF. TORQUE FT-LBF. 1-1/2 & 2 116-128 234-257 143-157 174-201 114-125...
Page 8
D I S T R I B U T E D V A L V E S VALVES & MEASUREMENT 3250 Briarpark Drive, Suite 300 Houston, TX 77042 USA Toll 800 323 9160 For the most current contact and location information go to: www.c-a-m.com Installation, Operation and Maintenance Manual 01/2011 / IOM-WHE-CHECK-822...