Table of Contents
Advertisement
Annex
A. Assembly instruction for retrofit of models with decorative panels
WARNING : If the HEATFLOW S5 was disassembled, decorative panels must be put back on the stove.
1.
Unscrew the 3 screws (AA)
behind the decorative panel (BB).
2.
Gently
twist
panel to remove.
3.
Repeat for the other decorative
panel.
*** Keep the decorative panels for
future use.
4.
Hammer the clips to flatten
them.
5.
Paint the sides of the stove not
painted with the flat black spray paint
accessory. (AC05956)
B. Retrofit of a double wall pipe
The HEATFLOW S5 can only be assembled with a SINGLE WALL PIPE
A pipe section can only have 1 single pipe shield
From Single wall pipe (DIMENSION "B")
CLEARANCE FROM SINGLE WALL PIPE SHIELD SBIHA APPROVED TO COMBUSTIBLE
To Ceiling (DIMENSION "A")
To Wall (DIMENSION "D")
*** note: For product other than SBIHA, the clearance is 9"
The retrofit of a double wall pipe to a single one can be done by placing a pipe shield on part of the pipe
•
at places where the clearance from combustible materials is less than 18in (0.46m).
The clearances with a pipe shield are presented in table above.
•
The retrofit with a pipe shield may require the user to move the stove away from the wall (Dimension
•
"C").
Next schematic is for reference:
Installation Instruction HEATFLOW S5
the
decorative
WARNING
CLEARANCE FOR COMBUSTIBLE MATERIALS
MATERIAL
CANADA
9" MIN
6"*** MIN
English
18in MIN
U.S.
9" MIN
6" MIN
46310A
2023-03-15
22
Advertisement
Table of Contents
