Table of Contents
Advertisement
APPLY EFFECTS
Blackbox has two effects that can be applied to as many pads as you want. You apply an
effect by selecting the send amount for the pad for each of the desired effects (FX1 or FX2)
and then configuring the parameters for that effect. After the effect is applied, the wet
signal is routed to Audio Out 1. All pads will get the same parameter values for an effect.
To Route a Pad to an Effect
1.
Push the FX button to go the effects Screen.
2.
On the effects screen, select the pad that you want to use.
3.
Turn the top left knob near FX1 to set the FX1 send amount
for the pad. This is the amount of the signal from this pad
that you want to send to FX1 for effects processing. You can
also use the touch screen to slide the level selector next to
the knob to the desired position. When a pad is sending
some of its signal to FX1, a blue triangle is displayed in the
top left corner of the pad. You can repeat this step for FX2
and a blue triangle will appear in the top right corner of the
pad.
To Modify Effect Parameters
1.
Push the FX button to display the effects screen.
2.
Touch the FX1 or FX2 box in a lower corner of the screen to
select it. The currently selected effect is highlighted pink.
3.
Push INFO to display the effect parameters screen for the
selected effect.
Turn the knobs or touch the onscreen buttons to adjust the effect
parameters. You will hear the impact of the parameter changes in
real time. You can also touch a knob on the screen and slide your
finger left and right or up and down to adjust the value. Here are the
available effect parameters:
Copyright 1010music LLC 2023
Blackbox 3.0 User Manual
FX Screen
FX1 Parameters
Screen
Page 81 of 123
Advertisement
Table of Contents
