2H5/2HS
6. Confirm that downloading was finished nor-
mally (See previous page).
7. Turn power off.
8. Remove the memory card.
9. Secure the optional interface slot cover by
using two screws.
10. Close the rear cover.
11. Turn power on again.
Check the printer gets ready and Ready
indicator is lit.
12. Print a status page (See page P.1-3-2).
13. Confirm the status page shows the new
firmware version.
1-6-4
All manuals and user guides at all-guides.com
Memory card slot
Memory card
Optional interface
slot cover
Figure 1-6-5
Screw
Screw