Kyocera FS-1100 Service Manual page 43

Code Contents
6000 Broken fuser heater lamp wire
The fuser temperature does not rise after
the fuser heater lamp has been turned
on.
6020 Abnormally high fuser thermistor
temperature
Fuser thermistor detects abnormally
temperature.
6030 Broken fuser thermistor wire
Input from fuser thermistor is 0 (A/D
value).
All manuals and user guides at all-guides.com
Causes
Poor contact in the
fuser thermistor
connector termi-
nals.
Poor contact in the
fuser heater lamp
connector termi-
nals.
Fuser thermistor
installed incor-
rectly.
Fuser thermal cut-
out triggered.
Fuser heater lamp
installed incor-
rectly.
Broken fuser
heater lamp wire.
Shorted fuser ther-
mistor.
Defective control
PWB.
Poor contact in the
fuser thermistor
connector termi-
nals.
Broken fuser ther-
mistor wire.
Fuser thermistor
installed incor-
rectly.
Fuser thermal cut-
out triggered.
Fuser heater lamp
installed incor-
rectly.
Broken fuser
heater lamp wire.
Remarks
Check procedures/corrective measures
Reinsert the connector (See page 1-5-16).
Reinsert the connector (See page 1-5-16).
Replace the fuser unit (See page 1-5-16).
Replace the fuser unit (See page 1-5-16).
Replace the fuser unit (See page 1-5-16).
Replace the fuser unit (See page 1-5-16).
Replace the fuser unit (See page 1-5-16).
Replace the control PWB (See page 1-5-
19).
Reinsert the connector (See page 1-5-16).
Replace the fuser unit (See page 1-5-16).
Replace the fuser unit (See page 1-5-16).
Replace the fuser unit (See page 1-5-16).
Replace the fuser unit (See page 1-5-16).
Replace the fuser unit (See page 1-5-16).
2H5/2HS
1-4-7