Riso VALEZUS T1200 Troubleshooting Manual page 33

Side air adjustment levers:
Normally, set the lever to "
feeding is a problem, set this to "
For more information, see "Loading the Paper in
the Standard Tray" in the "User's Guide".
The angle of the stripper plate of the high
capacity feeder may not be properly adjusted.
Turn the stripper plate angle adjustment dial to
adjust the angle of the stripper plate to suit the
conditions.
When no paper is fed:
Turn the dial gradually to the left and adjust the
angle to a proper angle.
When multiple sheets of paper are fed:
Turn the dial gradually to the right and adjust the
angle to a proper angle.
• When adjusting the angle, be sure to
remove the paper from the standard tray
and lower the standard tray all the way to
the lowest position.
(NORMAL)". If paper
(CARD)".
The paper separation pressure of the high
capacity feeder may not be properly adjusted.
When no paper is fed, the back of a card is
damaged, or paper that can easily generate
paper powder is used:
Turn the dial to "A little weak".
When multiple sheets of paper are fed:
Turn the dial to "Strong".
• When adjusting the angle, be sure to
remove the paper from the standard tray
and lower the standard tray all the way to
the lowest position.
VALEZUS T1200 Troubleshooting Guide
2
31