Instructions For Washing The Tank - Checchi & Magli WOLF PRO Use And Maintenance Manual

Stopping due to end of fertilisation
The manufacturer recommends you stop
the fertilisation procedure when the tank
is completely empty.
Proceed as outlined below.
1) Stop the tractor.
2) Turn the key (A) on the main discon-
necting switch to the "OFF" position
to switch off the power supply.
3) Close the valve (C).
NOTICE
Disconnect the power supply connec-
tors (B) of the device before discon-
necting the planting unit from the
tractor.

Instructions for washing the tank

NOTICE
Wash the tank when it is completely empty to pre-
vent the liquid that comes out the drain pipe damag-
ing the electrical components.
Carry out the operations described.
1) Turn the key (A) on the main disconnecting switch to
the "OFF" position to switch off the power supply.
2) Close the valve (B).
3) Unscrew cap (C).
4) Screw the fitting (D) and the pipeline (not supplied
by the manufacturer) together.
5) Remove the cover (E).
6) Pour the clean water through the filter.
7) Collect the washing water that comes out of the fit-
ting (D) in a suitably sized container.
Prolonged disuse of the device
In the event of prolonged disuse of the device, proceed
as described.
1) Drain the tank.
2) Wash the tank (especially if it contains a solution with
fertiliser).
3) Make sure there is enough water in the tank, then
start the pump to wash the water system and the
nozzle.
4) Switch off the pump as soon as the system is empty
English language
INFORMATION FOR USE
A
B
UN41-0935UA
C
UN41-0936UA
8) Dispose of the washing water in compliance with ap-
plicable legislation.
to prevent damage to the electric pump.
5) Carry out a visual inspection to establish the struc-
ture's overall condition, focusing in particular on the
welding, to find damage due to ageing, wear, vibra-
tions, corrosion or weathering.
6) Check that the main fixing nuts and bolts are tight.
7) Grease to all the unpainted parts.
10
E
A
D
Use and maintenance
6
C
B