Power User Overclock Settings; Password Settings - JETWAY 916PCP User Manual

M/b for lga 775 pentium 4 processor

Hide thumbs

Table Of Contents

Table of Contents

CPU Clock Ratio

*** Current Host/PCI Clock is 133/33 MHz ***

Host/PCI Clock at Next Boot

*** Current DRAM Clock is 166MHz ***

DRAM Clock at Next Boot

CPU Vcore Select

VDD1.5V Settings

VRAM Settings

VRAM Under Voltage Protect

VDD1.5V Under Voltage Protect

↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit

F5:Previous Values

Host Clock at Next Boot

This item allows you to select CPU frequency step by step increasing.

The choice are: 533MHz CPU---133MHz~350MHz, 800MHz CPU---200MHz~350MHz

DRAM Clock at Next Boot

This item allows you select the DRAM Clock for DDR2 533/DDR2 400. The setting are:

By SPD, DDR2 533, DDR2 400

CPU Vcore Select

This item allows you select CPU Vcore Voltage by increase 0.0125V step by step from

0.8375V to 1.6V or the Default setting is Default (CPU manufacturer Default setting).

VDD1.5V Settings

This item allows you to select 1.5V of the AGP VGA card. The choice are: Default, 1.5V,

1.6V, 1.7V, 1.8V.

VRAM Settings

This item allows you to select DRAM Voltage. The choice are: 2.55V/2.6V/2.7V/2.8V.

3-13 Password Settings

Set Supervisor Password

Set User Password

↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit

F5:Previous Values

You can set either supervisor or user password, or both of them. The differences are:

Supervisor password:

Phoenix – AwardBIOS CMOS Setup Utility