JETWAY 916PCP User Manual page 26

(3) USB Port connector: USB2
(4) USB Port connector: UL1 (USB)
The connectors are 4-pin connector that connect USB devices to the system board.
(5) LAN Port connector: LAN
This connector is standard RJ45 connector for Network connector.
(6) PS/2 Mouse & PS/2 Keyboard Connector: KB (PS2 KB/MOUSE)
The connectors for PS/2 keyboard and PS/2 Mouse.
(7) Parallel Port Connector (25-pin female): PARALLEL
Parallel Port connector is a 25-pin D-Subminiature Receptacle connector. The On-board
Parallel Port can be disabled through the BIOS SETUP. Please refer to Chapter 3
"INTEGRATED PERIPHERALS SETUP" section for more detail information.
(8) VGA Connector (15-pin D-Sub) Connector: VGA (for 916GCP only)
VGA is the 15-pin D-Subminiature female connector for display monitor
(9) Audio Line-In, Lin-Out, MIC, Surrback, Surround, GEN/LEF Connector : J1
This Connector are 6 phone Jack for LINE-OUT, LINE-IN, MIC, Surrback, Surround,
GEN/LEF
Line-out : (GREEN)
Line-in : (BLUE)
MIC : (PINK)
Surrback : (ORANGE)
Surround : (BLACKNESS) Audio output to speaker-Center/Subwoofer speaker out
GEN/LEF: (GRAY)
(10) Serial Port COM1/COM2(COM2 only for 916PCP) :
COM1/COM2 is the 9-pin D-Subminiature mail connector. The On-board serial port can be
disabled through BIOS SETUP. Please refer to Chapter 3 "INTEGRATED PERIPHERALS
SETUP" section for more detail information.
(11) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
Audio output to speaker
Audio input to sound chip
Microphone Connector
Audio output to speaker-Rear speaker out
Audio output to speaker-Side speaker out
Line-IN
PS/2
PRINT
Mouse
COM1
PS/2
Keyboard
23
Line-OUT
Surrback
VGA
USB2
GEN/LFE
LAN
USB
MIC-IN
SURROUND