JETWAY 916PCP User Manual page 27

(12) Primary IDE Connector (40-pin block): IDE1 (Support ATA 100)
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s). If
you install two hard disks, you must configure the second drive to Slave mode by setting its
jumpers accordingly. Please refer to the documentation of your hard disk for the jumper
settings.
•
Two hard disks can be connected to each connector. The first HDD is referred to as the
"Master" and the second HDD is referred to as the "Slave".
•
For performance issues, we strongly suggest you don't install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.
(14) Serial-ATA Port connector: SATA1/SATA2/SATA3/SATA4
This connector support the provided Serial ATA IDE hard disk cable to connecting the
motherboard and serial ATA hard disk.
FDD
Pin 1
Floppy Drive Connector
IDE 1
Pin 1
Primary IDE Connector
SATA4
SATA3
SATA2
SATA1
Serial-ATA Port Connector
24