Celestron OMNI AZ 102 Instruction Manual page 7

INSTALLING THE SMARTPHONE ADAPTER
1. Open the eyepiece clamp and place it around the body of
the eyepiece. Tighten the clamp unit it is secure.
2. Use the phone clamp knob to open the phone holder
until your phone fi ts inside. Tighten it to secure your
phone in place.
3. Turn on the phone and open your camera app. Make sure
the fl ash is turned off.
4. Loosen the knob on the bottom of the adapter that secures
the phone clamp to the eyepiece clamp. Slide the phone
clamp up and down and rotate it left and right until your
camera is looking down through the eyepiece of the
telescope. Tighten the knob on the bottom of the adapter
to secure it in place.
5. Use the telescopes focuser to adjust focus of your camera.
Snap the image using your app.
USING THE BLUETOOTH REMOTE
1
To replace the battery, use a small Phillips-head
screwdriver to loosen the battery cover screw and slide
the cover downward. Install a fresh CR2032 battery
with the positive (+) side facing upward. Reposition
the battery cover and secure it in place by tightening the
battery cover screw.
4
Open your camera app. Press the button on the remote
to trigger the shutter on your phone.
2
Press and hold the button on the remote for 5 seconds.
A blue light will turn on and, after a few seconds, start
to blink. The remote is now in pairing mode.
5
If your camera is in video mode, you can press the button
once to start recording and again to stop the recording.
3
Using the Bluetooth settings on your phone, pair the device
called "GBshutter."
WARNING: KEEP BATTERIES OUT
OF REACH OF CHILDREN.
Examine the device and make
sure the battery compartment is
correctly secured, e.g. that the
screw or other mechanical fastener
is tightened.
• Do not use if compartment is not secure.
• Dispose of used button batteries immediately and safely.
Flat batteries can still be dangerous.
• Tell others about the risk associated with button batteries and how
to keep their children safe.
7