The Radio; Automatic Presetting; Manual Tuning; Selecting The Preset Channels - Panasonic SC-HT822 Operating Instructions Manual

The radio

Press [TUNER] to put the remote control in TUNER mode.
Numbered
buttons
ENTER

Automatic presetting

Up to 15 stations can each be set in the FM and AM bands.
1
Press [FM/AM] to select "FM".
2
Press [6] or [5] to tune to the
lowest frequency ("FM 87.9" MHz or
"FM 87.5" MHz).
3
Press and hold [ENTER].
Release the button when "AUTO" is displayed.
The tuner presets all the stations it can receive into the
channels in ascending order.
≥"SET OK" is displayed when the stations are set. The last
station to be set is then played.
4
Repeat steps 1 to 3 to set the AM
bands (the lowest frequency is
"AM 520" kHz).

Manual tuning

1
Press [FM/AM] to select "FM" or
"AM".
2
Press [6] or [5] to select the
frequency.
Press and hold [6] or [5] until the frequency starts
scrolling to start automatic tuning. Tuning stops when a station
is found.
Presetting the channel one by one
1
Tune to the station (➜ above).
2
Press [ENTER].
3
While "PGM" is flashing on the display
Press the numbered buttons to select
a channel.
Alternatively, press [W CH] or [X CH] then press [ENTER].
PGM
The station occupying a channel is erased if another station is preset
RQT7708
to that channel.
44
TV INPUT SELECTOR
DVD/VHS FM/AM
FM/AM
DVD VHS TV TUNER
TUNER
DISC 1 DISC 2 DISC 3
1 2 3
CH
DISC 4 DISC 5 CH
CH
4 5 6
PICTURE MODE
VOLUME
7 8 9
ENTER
SETUP
S10
100 0
SLOW/SEARCH
SKIP
JET REW CD MODE
OPEN/CLOSE/EJECT
MENU
TOP MENU
NAVI
DIRECT PLAY
NAVIGATOR LIST
ENTER
OSD/
DISPLAY RETURN
TV VOL TV VOL
RESET PAGE MIX 2CH REPEAT
TV/VIDEO GROUP SUBTITLE PLAY MODE
PLAY MODE
MULTI RE-MASTER C.S.M C.FOCUS PROGRESSIVE
SUBWOOFER LEVEL SFC SUPER SRND MUTING
1 2 3 4 5
DISC CHANGE
DISC
OPEN/CLOSE
POWER
Í /I
DISC CHECK
INPUT
SELECTOR
D I S C
5
4
3
STOP PLAY
2
1
- DEMO
INPUT SELECTOR

Selecting the preset channels

1
Press [FM/AM] to select "FM" or "AM".
2
Press the numbered buttons to select
the channel.
Alternatively, press [W CH] or [X CH].
To select a 2-digit number
e.g. 12: [S10] ➜ [1] ➜ [2].
When a stereo FM broadcast is being received.
ST
TUNED
∫ If noise is excessive in FM
Press [PLAY MODE] to display "MONO".
Press [PLAY MODE] again to cancel the
mode.
The mode is also canceled when you
change the frequency.
∫ FM frequency step
Main unit only
The step is factory-set to 0.2 MHz, but you can change it to receive
broadcasts allocated in 0.1-MHz steps.
1 Press [INPUT SELECTOR] on the main unit to select "FM".
2 Press and hold [INPUT SELECTOR].
After a few seconds the display changes to show the current
minimum frequency. Continue to hold the button down. The
minimum frequency changes and the step is changed.
To return to the original step, repeat the above steps.
[Note]
Any FM/AM frequencies preset in channels will be changed by this
procedure. Preset them again.
EJECT
CH
VOLUME REC
/REW FF/
STOP PLAY
UP
PHONES DOWN
MONO