Table of Contents
Advertisement
Index
Dimensions
Mounting
1. Mark the hole positions using the mounting bracket or
using the measurements on the diagram to the right.
Drill the holes and install the wall plugs.
2. Feed the PTZ cable loom through the bracket, then
secure using the short screws provided.
Attach the safety cable from the bracket to the dome.
3. Fit the PTZ to the wall using the screws provided. Ensure the PTZ cable enters via
a lower position so that water does not run down to the camera.
Use silicon sealant around the base and where the cable enters the PTZ. The
connections for the camera need to be installed in a waterproof box or similar.
© 2023 System Q Ltd
ZipDVR.com
3
Advertisement
Table of Contents
