Table of Contents
Advertisement
DESCRIPTION OF THE CST REMOTE CONTROL
D9
D2
D8
D6
D1 ON/STAND-BY (on/off) button
D2 SILENT button
D3 Air flow button
D4 Decrease button
D5 Countdown Timer
D6 MODE button
D7 Increase button
D8 myEcoReal Feel button
D9 Swing button (flap swing)
D10 Indication LED
USING THE CST REMOTE CONTROL
The CST remote control is an innovative technology that allows
a better wellbeings regulation, thanks to the sensors provided.
In order to optimize the wellbeings conditions around you, we
suggest you to keep it near you.
•
The remote control must be no more than about 10 meters
away from the appliance (fig. 10) (even in non line of sight).
The maximum range may be lower depending on the envi-
ronment. It belongs to Bluetooth class 2 device class.
•
The CST remote control must be handled with care. Do not
drop it or expose it to direct sunlight or sources of heat. It
is advisable to keep the CST remote Control Unit lied over a
table or a plan surface.
Do not hold the CST remote Control in your hand for long
time to avoid altering the reading of the sensors.
The CST sensors are also disabled if the CST remote control
is positioned at a distance less than 1 m from the unit.
•
The CST remote control is equipped with touch sensitive
buttons.
•
The CST remote control is equipped with a double color built-
in LED (D10) (white/red). White indications are used for:
-
signaling the touching of each button with 3 fast
flashes
-
every 30 seconds it blinks for data transmission
-
signaling the entering of pairing phase with periodic
D3
D5
D4
D7
C15
C8
C17
C10
C15
blinking
C8
-
signaling the batteries good status
C14
C17
•
The same indications but in red color mean that the batter-
C10
ies begin to be exhausted.
C15
C16
D10
Please note: The remote control can be safely stored in the ap-
C14
propriate compartment (A11).
C10
D1
C16
C3
TURNING THE APPLIANCE ON/OFF
C14
•
Plug into the outlet.
C2
•
Touch the
C16
C3
the air conditioner starts operating in the same mode as
when it was turned off.
C2
•
Touch the
appliance off.
Please note: Never switch the appliance off by removing the
plug. Always switch it off by touching the
ton (D1) and waiting few minutes before removing the plug.
Only in this way the appliance will perform the standard check-
ings.
SELECTING THE OPERATING MODES
The operating modes available on the CST remote control
through the MODE button (D6) correspond to those on the ap-
pliance control panel (C).
SELECTING THE TEMPERATURES
In conditioning mode touch button (D4) or (D7) to select
the desired temperature.
SELECTING THE AIR FLOW
In conditioning and fan modes, touch
the desired air flow.
The air flows available are:
Minimum air flow: when most silent operation is
desired.
Medium air flow: when the noise level needs to
be low but with a good comfort level.
Maximum air flow: for maximum performance.
Auto air flow
chooses the air flow based on the temperature
selected and the environmental conditions. This
selection is only available in conditioning mode.
myEcoReal Feel FUNCTION
myEcoReal Feel is the innovative De'Longhi technology that
works simultaneously on temperature reduction and humidity
control, securing best comfort level. With traditional systems,
during working time, optimal comfort conditions may be
18
C7
C5
C9
C6
C7
C12
C9
C13
C12
C8
C11
C13
C4
C11
C1
ON/STAND-BY button (D1). When turned on,
C4
C1
ON/STAND-BY button (D1) again to switch the
C3
C2
button (D3) to select
:
the appliance automatically
C5
C6
C7
C9
C12
C13
C11
C4
C1
ON/STAND-BY but-
Advertisement
Table of Contents
