Relay AnDi1 User Manual page 12

Quantity
Unit
Value
Installed ports
Write protection
EEPROM error
Calibration
required
Range overflow in
last measurement
Operating mode
Value at 0mA/0V
Value at 4mA
Value at 20mA/10V is the upper limit of the measuring range at 20mA or 10V.
Write protect
User Manual AnDi1 / AnDi2 / AnDi3 / AnDi4 ·10/2017 · VERSION 1.3
selects the measured physical quantity (e.g. pressure or external
temperature).
is the physical unit of the counter and of the pulse increment. The
selection list offers those units from the DIN EN 1434-3, which
correspond to the selected quantity.
is the current measured value. This value must be multiplied by
the selected physical unit.
shows the installed and available ports.
is marked, if the device is protected against programming. Then
you cannot configure the adapter. The protection can be removed
after opening the sealable housing and pressing the "Unprotect"
pushbutton for a minimum of 4 seconds.
is marked, if an error occured while reading the non-volatile
memory. In this case you must reconfigure the device !
is marked, if the internal calibration constants are corrupt. In this
case the measured values could be wrong. The device has to be
recalibrated by the supplier.
is marked, if the measured value extends the upper value of the
input range.
shows / selects operating mode of the A/D converter:
a) Sensor with 4..20mA signal
b) Sensor with 0..20mA signal
c) Sensor with 0..10V signal
You can only switch between current and voltage mode by setting
the jumper inside the device !
is the lower limit of the measuring range at 0mA or 0V in the
operating mode 0..20mA or 0..10V.
is the lower limit of the measuring range at 4mA in the operating
mode 4..20mA.
Transmits a command to the AnDi4 to activate write protect. The
AnDi4 then allows no further configuration. It is protected against
unnoticed manipulation.
AnDi1/2/3/4
12