Cover Installation - Siemens SQM5 Series Operation

Reversing actuator with analog input signal

Hide thumbs Also See for SQM5 Series:

NOTE:

Switch Cam I must not be set higher than:

90° when using feedback potentiometers

ASZxx..803 or ASZxx.30;

135° when using feedback potentiometers

ASZxx.833 or ASXxx.33

Cover Installation

Lift the two screws on the cover corners and slide the

cover end into the groove at the gear end of the

actuator. See Figure 7.

Press the cover into place and then press the screws

inward and tighten. See Figure 8.

Dimensions

Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and models as

design improvements are introduced. Product or company names mentioned herein may be the trademarks of their respective owners.

Siemens Industry, Inc.

Building Technologies Division

1000 Deerfield Parkway

Buffalo Grove, IL 60089

+ 1 847-215-1000

Figure 6. SQM5x.xxxRxx Dimensions in Inches (Millimeters).

Your feedback is important to us. If you have comments

about this document, please send them to

SBT_technical.editor.us.sbt@siemens.com

Figure 7.

The installation is now complete.

Document No. 129-400

Installation Instructions

October 2, 2009

Figure 8.

Document No. 129-400

Printed in the USA

Page 5 of 5

Table of Contents