Page 1
Hotflo Unvented point of use hot water For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - info@mytub.co.uk...
Page 2
Flexible siting is a key design feature that we insisted upon because it means there is no requirement for a cold water cistern. Hotflo can be used with standard or mixer taps and fed from the mains water supply provides high hot water flow rates.
Page 3
• IPX4 rated. • Kiwa approved to UK Water Supply Regulations. CE marked. * Figures are for guidance only, the Heatrae Sadia Specification Advice Team should be contacted to discuss requirements for specific sites. Capacity recommendations are based on BS 6700.
Page 4
T piece Cold mains feed To drain To provide an added level of safety, Heatrae Sadia recommend (waste) the fitting of a temperature and pressure relief valve on heaters of Hotflo...
Page 5
Accessories A full range of accessories are available for installation with Hotflo 10 and 15. Thermostatic blending valves allow water to be stored at high temperatures These are supplied as accessory packs. and blended with cold water to a preset outlet temperature.
Installation Guarantee Capacities Mechanical Hotflo carries a full two year transferable on-site 10 and 15 litres. Must be mounted in the vertical position with inlet / service support guarantee against faulty manufacture outlet at the top. Floor or wall-mounted (three screws...
Page 7
Dimensions and ordering Dimensions Ordering guide Model Rating Product @ 240V code (kW) Fixing centres Hotflo 10 95:050:148 of wall screws (unit hangs on Hotflo 15 95:050:149 keyhole slots) Replacement inner container with integral element 10 litre 95:608:916 15 litre...