positions. Do not adjust the flame between
and OFF.
If the burner does not light within 15 seconds, turn the control knob off and wait at least one
minute before trying again.
To switch the burner off, turn the knob clockwise until you hear the safety click.
After use, always turn the knobs to the off position.
Flame Failure Safety Feature
The flame failure probe cuts off the gas supply to the burner if the flame is blown out. When lighting the burner on flame
failure models, hold down the knob for approximately 10 seconds after the burner has lit. Releasing the knob too soon
will extinguish the flame. If the flames are accidentally extinguished, turn off the burner and do not try to light it again for
at least one minute (to allow the gas to disperse).
If the Cooktop Does not Light
If the cooktop does not light, check that:
• The cooker is switched on.
• The gas is turned on.
• You have held down the knob for at least 10 seconds.
• The ignitors are sparking. If the ignitors are not sparking, they may be dirty or wet. Clean them with a toothbrush
and methylated spirits, as shown.
https://producthelp.fisherpaykel.com/eu/Cook/Freestanding_Cookers/Dual_Fuel/OR90LDBGFX3/User_Guide_OR90LDBGFX...
Fig. 20 Cleaning the probe and ignitor
Updated: Thu, 06 Apr 2023 08:56:04 GMT
Powered by
3