Panasonic Toughbook CF-30CTQCXBM Reference Manual page 65

Disabling/Enabling Wireless Communication
<Only for model with wireless LAN, Bluetooth, and/or wireless WAN>
There are 5 ways of disabling and enabling wireless communication.
The wireless switch on the front of the computer (below)
Wireless Switch Utility (
Settings in the Network and Sharing Center (
Settings in the [Advanced] menu of the Setup Utility (
Setting in the Wireless Connection Disable Utility (
NOTE
For further information about Wireless LAN: (
For further information about Bluetooth: (
For further information about Wireless WAN: Refer to the instruction manual of the wireless device.
The wireless communication can be enabled or disabled by connecting or disconnecting the LAN cable. (
The Wireless Switch
To disable all wireless communication
1
Switch (A) to OFF.
To enable wireless communication
1
Switch (A) to ON.
In the default setting, the wireless switch enables all wireless devices when it is
set to ON.
To check the wireless communication status
1
Place the cursor over the Wireless Switch Utility icon (
A tool tip appears.
NOTE
If you uninstall the Wireless Switch Utility, set the wireless switch to ON beforehand.
Do not turn on/off the switch repeatedly at too short intervals.
Do not restart, log off, or enter sleep or hibernation immediately after turning on/off the switch.
Do not turn on/off the switch while Windows is starting up.
To use wireless communication, set the wireless devices ([Wireless LAN] / [Bluetooth] / [Wireless WAN]) to [Enabled]
(default) in the [Advanced] menu of the Setup Utility (
page 66)
page
page
page 73)
69)
page 80)
page 67)
69)
page 81).
65
or ) on the notification area.
page 67)