You can use the following procedure instead of turning on wireless LAN in the Wireless Switch Utility.
(Start) - [Control Panel] - [Adjust commonly used mobility settings].
Click [Turn wireless on] in [Wireless Network].
• When [Turn wireless off] is displayed, the wireless network is already on.
• If you cannot select [Turn wireless on], the wireless switch is turned off.
Setting the wireless LAN access point
Follow the instruction manual of the wireless LAN access point to make settings for the access point to recognize the com-
Turn the wireless LAN on.
If your computer is already connected to another network, click [Connect / Disconnect]. The [Connect to a network]
and select an access point, and click [Connect].
Input the key you set for the access point to recognize the computer, and click [Connect].
Wait for the computer to connect to the wireless LAN access point.
When [Successfully connected to XXXX] is displayed, the wireless LAN setting is complete.
[Save this network] : Add a check mark to save the password, settings, etc.
[Start this connection automatically] : Add a check mark so the computer automatically detects the access point
and connects to the Internet.
The settings depend on the network environment. For further information, ask the system administrator or the person
in charge of the network.
If you use the stealth type wireless LAN access point which restricts automatic detection of the wireless LAN access
point, take the following procedure.
If you do not perform the procedure below, you may not be able to access the wireless LAN access point automatically
or the wireless LAN access point may not be displayed on the [Connect to a network] screen.
on the notification area and click [Connect to a network].