Table of Contents
Advertisement
I-picture interval
Set the I-picture insertion interval.
Select Time to set in seconds.
Select Frame to set in frames.
H.264 profile
Set the profile setting for H.264 video codec to high,
main or baseline. The video compression efficiency is
high, main and baseline in sequence. The specified
profile may not be available depending on the program
you use. Select the profile which is suitable for your
program.
Bit rate compression mode
Select CBR, VBR or Adaptive rate control.
If you want to keep the bit rate fixed, select CBR. If you
want to keep the image quality fixed, select VBR.
If you select Adaptive rate control, the bit rate is
automatically optimized for unstable network
connections or wireless networks with a lot of
interference.
Notes
• The frame rate or bit rate that is actually transmitted
may be different from the set values depending on
image size, scene, network environment.
• The Adaptive rate control cannot operate when the
Plug- in free viewer is being used.
• If you want to use the Adaptive rate control, set the
connection method in the live viewer to Unicast. If
you set TCP as a connection method, the adaptive rate
control will be disabled. For details, refer to
"Switching Transmission Mode" in "Operating the
Camera" on page 19.
Bit rate
When you set Image codec to H.264 and set Bit rate
compression mode to CBR, the bit rate of the image
transmission for a line can be set.
When the bit rate is set to a high level, a high image
quality can be enjoyed.
Maximum bit rate limit
Enable the check box when Bit rate compression mode
is set to VBR, to set the maximum value of the bit rate.
Max: Set the maximum value of the bit rate when the
camera is operated with VBR.
Accept frame skip: If you enable the checkbox, the
frame skip will be allowed for bit rate control.
Min, Max
Set the maximum and minimum bit rates that are
adjusted with the adaptive rate mode when Bit rate
compression mode is set to Adaptive rate control.
Setting the Camera Image and Audio — Video / Audio Menu Setting the Camera Image — Video Menu
Image quality
If you set Image codec to JPEG, or Bit rate
compression mode to VBR when Image codec is set to
H.264, the image quality setting will be enabled.
Selectable values are from 1 to 10. When 10 is selected,
the best image quality is achieved.
Bandwidth control
Limits the network bandwidth for the JPEG image data
output from the camera when you set Image codec to
JPEG.
Note
Audio may be interrupted depending on the selected
bandwidth. In this case, select a wider bandwidth. This
function is not available when the setting is set to 0.
OK/Cancel
See "Buttons common to every menu" on page 23.
Audio Tab
Audio sending
Make settings for sending audio from the m
microphone input connector or the built-in microphone.
Enable
Select the checkbox if you want to send audio from the
network camera.
Note
When you change the Audio setting, click Refresh on
the Web browser to reflect the change on the opening
live viewer page.
Audio in
Select microphone input or line input.
SNC-XM637/XM636/XM632/CX600W/CX600
models only have a built-in microphone. An audio
cannot be selected.
Mic volume
When the Audio in is set to the microphone input, set the
volume level of the audio input from the m microphone
33
Advertisement
Table of Contents
