Table of Contents
Advertisement
Edge Storage movie
Recording status
Display the current recording status.
The recording status will not be updated until the screen
is refreshed.
Use the Start Recording and Stop Recording button to
start or stop the recording manually.
Note
When recording manually, do not set Edge Storage
movie in the Execution Condition tab of the Action
output menu to Off.
Recording target
Video: Select the video codec mode you want to record.
For detailed settings of video codec mode, see the
Video codec tab in the Video / Audio menu.
Audio: Set whether to record the audio signals input
from the camera.
Select the checkbox to record.
Note
Set Audio sending (page 33) in the Audio tab of the
Video / Audio menu to Enable.
Recording capacity
Displays the maximum recording time in the current
camera setting of the video mode, image size, bit rate
and frame rate.
Pre-alarm period: Displays the maximum recording
time before the alarm is triggered.
Post-alarm period: Displays the maximum recording
time after the alarm is triggered.
Note
Maximum recording time varies depending on the
image size and quality setting in the Video / Audio
menu.
Recording time
Set the recording time for the Pre-alarm image/audio
and Post alarm image/audio.
Pre-alarm period: Type the recording time of the
image/audio before alarm detection.
Post-alarm period: Type the recording time of the
image/audio after alarm detection.
OK/Cancel
See "Buttons common to every menu" on page 23.
Voice alert Tab
Set the voice alert function to output audio from the
speaker connected to the line output jack of the camera
or the build-in speaker of the camera when an alarm is
triggered by the sensor input or detection functions.
Note
Before using the voice alert function, you need to save
the audio file to the camera using the SNC toolbox. You
can download SNC toolbox and application guides from
the download site.
Voice alert 1, 2, 3
Up to three voice alerts can be set. Configure the
following setting for each voice.
File
Displays the name of the audio file saved in the camera.
"Not uploaded" is displayed dimly if no audio file is
saved.
To delete the audio file saved in the camera, click
Delete.
Note
Before deleting an audio file, set Voice alert to Off.
Voice alert is included in the Execution Condition tab of
the Action output menu.
Test
When an audio file is saved in the camera, you can check
it by playing it back.
Click Play to play back the audio file.
Repeat
Select playback repeat time from 1 to 3.
Setting the Action output — Action output Menu
69
Advertisement
Table of Contents
