Table of Contents
Advertisement
Wi-Fi Tab
Display sample: SNC-CX600W
Supported models: SNC-CX600W
Use this tab to set the connection of the Wi-Fi network.
Notes
• A wired network and a Wi-Fi network cannot be used
at the same time.
• The IP address of a Wi-Fi network will be assigned
only when a wired network is not connected.
Wi-Fi network connection check
Displays the current connection status of a Wi-Fi
network.
If the camera is connected to a Wi-Fi router, the display
will be highlighted.
SSID
Displays SSID of the Wi-Fi router that can be connected
to.
Security
Displays the current setting method as either
authentication or encryption.
None
Connect to a Wi-Fi router without encryption.
WEP
Connect to a Wi-Fi router using WEP (Wired Equivalent
Privacy).
WPA/WPA2
Connect to a Wi-Fi router by performing an
authentication which is compliant to WPA/WPA2
(Wi-Fi Protected Access).
Channel
Displays the wireless channels of a Wi-Fi router that can
be connected to.
Signal
Displays the signal strength. If it is lower than 60%,
improve the installation environment as follows:
1
Change the installation position of the camera.
2
Adjust the antenna angle of the Wi-Fi router.
3
Change the installation position of the Wi-Fi router.
4
Install a repeater.
Note
The displayed signal intensity is an estimate. If the
number is small, the connection may break easily.
Refresh
Refresh the Wi-Fi network display.
Note
When you click Refresh, video or images may be
interrupted.
Manual setting of a Wi-Fi network
You can set the connection of a Wi-Fi router manually.
Before connecting, locate the Wi-Fi router setting
information (SSID, authentication, encryption, key or
password, etc.).
Configuring the Network — Network Menu
41
Advertisement
Table of Contents
