Ingersoll-Rand 232TGSL Operation And Maintenance Manual page 16

1. Coat Hammers (33) with a light film of
Ingersoll- - Rand No. 100 Grease.
2. Replace Hammers in Hammer Frame (30) exactly as
they were when you marked them prior
If you are installing new Hammers or want to
change the location of the existing Hammers
to utilize both impacting surfaces, slide the
Hammers in the Hammer Frame so that the
half- - round notch on one Hammer is located on one
side of the Frame and the half- - round notch on the
other Hammer is located on the other side of the
Frame.
Maintenance Section (Continued)
3. Replace Hammer Pins (31).
4. Examine base of Anvil (40) and note its contour.
Assembly of the Impact Wrench
1. Set assembled impact mechanism down over splined
2. Smear a thin film of Ingersoll- - Rand No. 100 Grease
3. Install Hammer Case Cap Screws (38). Tighten
16
While looking down through the
hub of Rotor.
on inside surface of Hammer Case
Hammer Case Cap Screws to 60 to 70 in- - lb.