Advertisement
SAFETY
NOTE: A transfer switch must be installed by a qualified
electrician in accordance with applicable electrical
codes. Some jurisdictions may require the installation
to be inspected by local authorities. Keep all relevant
installation, inspection, and maintenance information.
l Never use the generator to power medical support
equipment.
l Never expose the generator to rain, snow, water spray,
or standing water while in use. Store and operate the
unit in a dry or covered (but not enclosed) location.
l Do not let children or untrained individuals operate the
generator.
l Keep children, bystanders, and pets a minimum of 10 ft.
away from a running generator.
l Maintain Safe Distance. While operating and storing,
keep at least five feet of clearance on all sides of the
generator, including overhead. Turn the unit off and
allow it to cool a minimum of 30 minutes before storage.
Heat created by the muffler and exhaust gases could
be hot enough to cause serious burns and/or ignite
combustible objects.
l Do not operate the unit in areas where combustible or
hazardous materials are stored including gasoline and
natural gas filling stations.
l Do not operate the generator while barefoot, with
wet hands or feet, while standing in water or in wet
conditions.
l Do not use this unit when you are tired or under the
influence of drugs, alcohol, or medication.
l Burn Hazard. Do not touch hot surfaces.
l Do not contact the muffler or engine. They are very
HOT and will cause severe burns. Do not put body parts
or any flammable or combustible materials in the direct
path of the exhaust.
l Keep hands, fingers, feet, and other body parts away
from all moving parts of the generator.
l Do not connect worn or damaged electrical cords to the
generator. NEVER touch frayed or exposed wires.
l Do not operate the generator on an incline. The unit
should always be placed on a flat stable surface.
l Check the physical condition of the product prior to each
use. Look for loose bolts, fluid leaks, and other signs
of wear. Replace all damaged items. For replacement
parts or assistance, contact our customer service team.
l For optimal performance, use the generator in
temperatures between 23°F (-5°C) and 104°F (40°C)
with a maximum relative humidity of 90%.
6 | English
l Before starting the generator, check all fluids (oil and
gasoline).
l Do not remove the oil dipstick or fuel cap when the
generator is running.
l Securely tighten the oil dipstick after adding oil and the
fuel cap after adding gasoline.
l Avoid skin contact with engine oil or gasoline. Wear
protective clothing and equipment. Wash all exposed
skin with soap and water. Prolonged skin contact with
gasoline or engine oil may cause severe skin irritation
and other adverse reactions.
l Generator's
vibrate
operation. Check the generator and all of the cords
connected to it for any damage that may have resulted
from the vibration. Replace or repair damaged items
as needed. Do not use the generator or any items that
show signs of damage.
l All electrical tools and appliances operated from this
generator must be properly grounded by use of a third
wire or be double-insulated.
l Before transporting the generator, disconnect the spark
plug boot, drain the fuel tank and properly restrain the
unit.
l Fuel or oil may leak from the generator during transport.
Place a towel, plastic sheet, or absorbent pad beneath
the unit to protect your vehicle.
l To prolong the life of this product, follow the instructions
in the Care and Maintenance section of this manual.
l Replace damaged or worn items with recommended
or equivalent replacement parts. Using an incorrect
or incompatible part might create a hazard that could
result in serious personal injury.
l Always remove any tools or other service equipment
used during maintenance away from the generator
before operating.
GROUNDING
See Figure 3.
WARNING
properly ground the generator can result in electric
shock.
NOTICE
extension cords, tools, and appliances, or double-
insulated tools and appliances.
and
bounce
during
Shock hazard. Failure to
Only use grounded 3-prong
normal
Advertisement
