Advertisement
CARE AND MAINTENANCE
WARNING
the spark plug boot (see figure 18) from the
spark plug when performing maintenance on the
generator.
WARNING
items with recommended or equivalent replacement
parts. Using an incorrect or incompatible part might
create a hazard that could result in serious personal
injury.
WARNING
for 30 minutes before performing any maintenance
procedure.
WARNING
engine oil or gasoline. Wear protective clothing
and equipment. Wash all exposed skin with soap
and water. Prolonged skin contact with gasoline
or engine oil may cause severe skin irritation and
other adverse reactions.
NOTICE
of the product prior to each use. Look for loose
bolts, fluid leaks, and other signs of wear. Replace
all damaged items. For replacement parts or
assistance, contact our customer service team.
To prolong the life of this product, follow the care
and maintenance instructions in this section. Contact
customer service before servicing any recall or warranty
parts.
CLEANING THE GENERATOR
Do not store or operate your generator in dirty, dusty, or
corrosive environments. Do not allow foreign materials
and debris to clog the vents on the unit.
NEVER clean the generator with a garden hose. Water
can damage the generator's fuel system and electrical
components. If the unit needs to be cleaned, use a soft
brush and damp cloth to clean the exterior and use low
pressure air (no greater than 25 psi) to clean the vents.
Never use gasoline as a cleaning agent.
CLEANING/REPLACING THE AIR FILTER
See Figure 14.
Keep air filter clean. A dirty air filter can cause poor
performance and decrease the service life of the
product. NEVER operate the generator without an
air filter in place.
l Turn the generator off and allow the engine to cool for
30 minutes.
l Turn the lock knob to the unlocked position.
Accidental start-up. Disconnect
Replace damaged or worn
Allow hot components to cool
Avoid
skin
contact
Check the physical condition
l Remove the engine service cover.
l Gently depress the latch on the side of the air filter cover
and remove the cover.
l Remove the air filter from the air cleaner housing and
place it in a suitable cleaning container. Replace the air
filter if damaged.
NOTE: The air filter may be covered in oil. Use an
appropriate container.
l Wash the air filter by submerging the filter in a solution
of household detergent soap and warm water. Slowly
squeeze the filter to thoroughly clean.
NOTICE
filter during cleaning or drying. Only apply slow but
firm squeezing action.
with
l Rinse the air filter by submerging it in fresh water and
applying a slow squeezing action. Allow the filter to dry
thoroughly.
NOTICE
guidelines of the EPA or other governmental
agencies
materials. Consult local authorities or reclamation
facility.
l Dip the air filter in clean engine oil then squeeze out all
excess oil. The engine will smoke when started if too
much oil is left in the filter.
l Install the air filter in the air cleaner housing and reinstall
the air filter cover.
l Install the engine service cover and turn the lock knob
to the locked position to secure.
FIG. 14
A - Air Filter Cover
B - Air Filter
DO NOT twist or tear the air
Do not pollute. Follow the
for
proper
disposal
B
A
of
hazardous
English | 19
Advertisement
