Advertisement
COMPONENTS
FIG. 5
B
C
A
D
E
U
N
O
A - Output Ready LED
B - Overload LED
C - Low Oil LED
D - Service Generator LED
E - Automatic Shutoff LED
F - Reset Button
G - ECO Mode Switch
UNDERSTANDING YOUR GENERATOR
See Figure 5.
To reduce the risk of injury and product failure, read
and understand the information in this user's manual
as well as the information on the product labeling.
120 VOLT AC, 20 AMP RECEPTACLES
This unit has two single phase, 60 Hz receptacles
capable of carrying a maximum of 20 amps.
ACCESSORY TRAY
The accessory tray is ideal for storing cell phones, tablets,
and other devices while they charge. DO NOT stand
near generator while your device charges. Always
maintain a safe distance while the generator is in use.
CIRCUIT BREAKER (20 AMP)
The 20 amp circuit breaker protects devices and
equipment connected to the 120V receptacle from
electrical overload.
H
G
F
M
H - 120 Volt AC 20 Amp Receptacles
I - 20 Amp Circuit Breaker
J - Main Circuit Breaker (9 Amp)
K - Parallel Operation Outlets
L - USB Ports
M - Ground Terminal
N - Engine/Fuel Control Switch
I
J
L
R
S
O - Recoil Handle
P - Vented Fuel Cap
Q - Spark Plug Service Door
R - Engine Service Cover
S - Lock Knob
T - Muffler/Spark Arrestor
U - Accessory Tray
CO SENSOR INDICATOR LIGHTS
The CO Sensor monitors for the accumulation of
poisonous carbon monoxide gas. If increasing levels
of CO gas are detected, the CO Sensor automatically
shuts down the engine.
ECO MODE SWITCH
Eco mode minimizes fuel consumption and noise by
adjusting the engine RPM to the minimum required for
the current load.
ENGINE/FUEL CONTROL SWITCH
Rotate the engine/fuel control switch to set the choke
and start or stop the flow of fuel.
ENGINE SERVICE PANEL
Turn the lock knob to unlock and remove cover to
service the oil, spark plug, and air filter.
K
P
Q
English | 11
T
Advertisement
