Date And Time; Your Logo (Kx-Mb2030 Only) - Panasonic KX-MB2000 Operating Instructions Manual

2. Preparation

2.8 Date and time

We recommend you to set the date and time. The other
party will receive your unit's date and time as the header
information.
MFaxN
* The pictured model is KX-MB2030.
1
MMenuN A MBNM1NM0NM1N A MSetN
2
Enter the current month/date/year by selecting 2
digits for each.
Example: August 3, 2010
M0NM8N M0NM3N M1NM0N
3
Enter the current hour/minute by selecting 2 digits for
each.
Example: 10:15 PM (12 hour clock format)
1. M1NM0N M1NM5N
2. Press MGN repeatedly to select "PM".
4
MSetN
5
Press MMenuN to exit.
Note:
R To check the current date and time setting, press
MFaxN to temporarily change the unit to the fax mode
(KX-MB2030 only).
R Your unit's date and time will be used as the header
information for the following:
– When sending as an attached file to an email
destination directly from this unit (Scan to email
address) (page 31).
– When sending faxes (page 41) (KX-MB2030
only).
R If the date and time is not set correctly, the other party
will receive an incorrect date and time as their
header. This may confuse the other party.
To correct a mistake
Press MFN or MEN to move the cursor to the incorrect
number, and make the correction.
If you have subscribed to a Caller ID service
(KX-MB2030 only)
The date and time will be automatically set according to
the received caller information.
R If the time has not previously been set, Caller ID will
not adjust the clock.
R You can turn this feature OFF (feature #226 on
page 57).
22
MMenuN
MSetN MFNMEN
For assistance, please visit http://www.panasonic.com/help

2.9 Your logo (KX-MB2030 only)

You can program your logo (name, company name, etc.)
so that it appears on the top of each page sent.
1
MMenuN A MBNM1NM0NM2N A MSetN
2
Enter your logo, up to 30 characters (see page 71
for character entry). A MSetN
3
Press MMenuN to exit.
To correct a mistake
Press MFN or MEN to move the cursor to the incorrect
character, and make the correction.
R To erase all characters, press and hold MStopN.
MMenuN MStopN
MSetN MFNMEN