Panasonic KX-MB2000 Operating Instructions Manual page 68

9. Programmable Features
Feature/Code
Approving users for the LAN
connection
MBNM5NM3NM2N
Setting the IP address
automatically for the LAN
connection
MBNM5NM3NM3N
Setting HTTPD for the LAN
connection
MBNM5NM3NM4N
IPv6 protocol
MBNM5NM3NM5N
Setting the primary WINS
server for the LAN
connection
MBNM5NM3NM8N
Setting the secondary WINS
server for the LAN
connection
MBNM5NM3NM9N
68
Selection
M0N "DISABLED" (default): Deactivates this feature.
M1N "ENABLED": The unit will deny/approve access from the pre-programmed
IP patterns. You can program whether to deny or approve IP addresses. Up to
4 patterns each for IPv4 and IPv6 can be programmed through the web browser
interface.
1. Start Multi-Function Station.
2. [Utilities] A [Configuration Web Page] A [Network Configuration]
3. Type "root" as the user name, then enter the password (feature #155 on
page 56). A [OK]
4. Select the [LAN FEATURE] tab.
5. Click [Edit] next to [APPROVED USERS].
6. Click [Edit] next to [FILTER (IPv4)]/[FILTER (IPv6)].
7. Change the mode and edit IP filtering information. A [Submit]
8. Close the web browser.
This feature will be displayed only when feature #500 is activated.
M0N "DISABLED" (default): Deactivates this feature.
M1N "ENABLED": IP address will be allocated automatically without using a
DHCP (Dynamic Host Configuration Protocol) server.
M0N "DISABLED": Denies access to the web browser.
M1N "ENABLED" (default): Allows access to the web browser.
M0N "DISABLED" (default): Deactivates this feature.
M1N "ENABLED": IPv6 protocol can be used. After installing the printer driver,
be sure to change the port to IPv6 protocol. You can check the IPv6 protocol
address by printing the "SETUP LIST" (page 96).
Note:
R To activate this feature, you need to turn the power switch of the unit OFF,
then ON.
This feature is available when feature #500 is deactivated.
1. MMenuN A MBNM5NM3NM8N A MSetN
2. Enter the primary WINS server of the network on the LAN using the dial
keypad. A MSetN A MMenuN
This feature is available when feature #500 is deactivated.
1. MMenuN A MBNM5NM3NM9N A MSetN
2. Enter the secondary WINS server of the network on the LAN using the dial
keypad. A MSetN A MMenuN