Table of Contents
Advertisement
Display Panel Instructions
Others menu
No.
Item
01
Checking the version
02
Setting the buzzer
03
Setting the SCSI ID
04
Setting the terminator
Setting the transfer
05
rate
Checking the roller
cleaning warning
06
Clearing the roller
cleaning warning
Checking the roller
modules replacement
warning
07
Clearing the roller
modules replacement
warning
08
Setting the product ID
Setting the sleep
09
mode
20
LCD
Displays the firmware version of the mechanical
control, pre-imprinter or post-imprinter.
Version
If an optional imprinter is not installed, the imprinter
version will not be displayed.
Selects whether the buzzer is turned on or off.
If selection is in the "ON" position:
When pressing a key, one short beep will be heard.
Buzzer
When there is an error, 5 short beep will be heard.
When scanning is completed correctly, one long beep
will be heard.
SCSI ID
Sets the SCSI ID No.
Set "Enable" or "Disable".
Terminator
"Enable": If last device on chain
"Disable": If between devices
•
Changes the maximum value of the synchronous
transfer rate of the SCSI interface.
•
Transfer Rate
Lower the synchronous transfer rate to 10 Mbytes/
sec. if the computer has failed to recognize the
scanner or the scanner fails to operate properly.
The alarm tells you it is time to check roller.
Clean Roller
If it is near 100%, clean the roller. See "Cleaning the
Unit" on
Clean Roller
Clear the "Clean Roller Warning ≤≤%" display.
The alarm tells you the roller needs to be changed.
If it is near 100%, replace the paper feed roller module
Replace Roll.
and retard roller module. See "Replacing Consumable"
on
page
Replace Roll.
Clear the "Replace Roll. Warning ≤≤%" display.
Selects the product ID. The product ID setting depends
on the host computer scanner application you are
Product ID
using.
Allows scanner to emulate other Panasonic scanner.
Sleep Mode
Sets the time until sleep mode turns ON.
Content
page
44.
52.
Page
30
31
32
Advertisement
Table of Contents
