Table of Contents
Advertisement
IN CASE OF DAMAGE: keep the unit away from flames or ignition sources. Ventilate the premises well
for a few minutes. Switch the unit off, pull out the power plug. Inform an Authorized Service Centre.
Repairs are carried out only by persons trained or recommended by the manufacturer
CAUTION: maintenance should be carried out only by qualified personnel. Children should be
supervised to ensure they do not play with the unit.
CLEANING THE DISPLAY CASE
1) Once a day clean the inside surfaces is recommended
2) Every week clean the outer surfaces of the display case with a special cleaner which is not
peeling or damage on the surface coating of the component. Wipe carefully with a soft cloth.
Never clean it using inflammable or scouring agents, alcohol, acetone or solvents. NEVER
CLEAN THE DISPLAY CASE BY THE USE OF WATER JETS. Clean glass surfaces using glass-
cleaning products exclusively. The use of water is not recommended here, as it may cause
scale to build up.
CAUTION: NEVER WASH OR CLEAN THE UPPER PART OF THE DISPLAY CASE WITH WATER OR
LIQUIDS
Every six months clean the grates under the superstructure bottom shelves. Proceed as follows.
• Disconnect the display case from the electrical power supply by the wall main cut-off switch
(fig. 17).
• Empty the appliance
• Wait until the surfaces have reached ambient temperature.
• Clean the inside of the display case thoroughly with special cleaner. Wipe carefully with a soft
cloth.
• After having carefully checked that the display case is completely dry inside, start the
appliance again by the wall cut-out switch.
• Allow a couple of hours before loading the products back again.
Attention! Disassemble and assemble very slowly, using heavy-duty gloves. It is advisable to have these
cleaning operations carried out by authorized service personnel.
ANY MAINTENANCE OPERATION NOT INCLUDED AMONG THE FORMER STEPS MUST BE CARRIED OUT
BY THE AUTHORISED AFTER-SALES SERVICE OR BY QUALIFIED PERSONNEL.
LIGHTING: lamps must be replaced by the after-sales service only. Resort to it if need be.
AVOID:
• The use of abrasion on the surface of steel.
• Do not leave water on steel surfaces. Chlorides in the water will break down the passive layer
and rust your stainless steel. To prevent stainless steel rust, use non-abrasive tools to clean
your stainless steel
ATTENTION: It is quite obvious, but we must point out that when cleaning the cabinet, water must
not be introduced directly. We have a lot of electrical parts and especially in the Model with HOT Air
Venti-lation system, we have a HEATER Finned resistor.
11. EMERGENCY SITUATIONS
1) The display case will not start or will not keep on working:
• There may be a general black-out.
12
IA0010125.B
Advertisement
Table of Contents
