Table of Contents
Advertisement
EQUIPMENT OPERATION
Operating guidelines
1
2
3
Attention
The unit is designed with overheating protection, to avoid extended and continuous
operation for long time. When the red light is on, the device cannot be activated, even if
it is forced to do so. The unit remain idle for about 20 minutes and can be restarted after
the green light illuminates.
Open the lid, as shown, place the objects in the basket and
then place them in the cleaning tank. Add water to a level
between "MIN" and "MAX" and above the objects.
If the device is switched on without water, the ultrasonic
energy will not be absorbed. After more than15 seconds,
this procedure can damage the device or drastically
reduce its lifetime.
Connect the power cord into a power outlet and turn the
switch on. The LED display shows
This is the most common configuration of the clock and or
operating status. If the clock needs to be adjusted, press the
TIME button
. (As required) The clock can be set between
1 and 30 minutes.
The periods of common cleaning are 5, 10 and 15 minutes.
The extension of the cleaning period can result in:
a. Loosening the screws (if used).
b. Increased preexisting cracks.
c. Peeling on the lining of the object.
Press the On/Off button once to start the cleaning.
During cleaning, the two blue LEDs from the unit will light,
a humming can be heard coming from the cleaning tank,
indicating that cleaning is in progress.
Closing the lid will reduce the noise level.
The LED display will count down, showing the remaining
cleaning time. When the display reads 0:00, the cleanup is
complete. To interrupt the cleaning at any time, press the
On/Off button.
17
.
Advertisement
Table of Contents
