Special Cleaning - SAEVO BIO FREE 6L Owner's Manual

EQUIPMENT OPERATION
4

Special cleaning

5. When cleaning is complete, remove the basket and objects. If there are many objects and some
debris remaining, add 5 minutes and repeat the cleaning.
6. Follow steps 5 and 6 in the advanced cleaning section to drain the dirty water, add clean water,
wash objects for more 3 minutes to remove the residual chemicals.
Attention
During cleaning the debris separate from the objects as "smoke". The water becomes
blurred. This method will remove the rust and will cause objects to appear as new.
Objects made of silver, copper or brass darkened by
oxidation need special cleaning.
Appropriate places: Manufacturers of products made of
copper, silver or bronze.
Cleaning methods:
1. Place the objects in the basket and then in the tank; add
water to a level between MIN and MAX above the objects.
2. Turn the main switch on. Press the TEMP button to set
the temperature of the water to 50ºC. Press the TC button
to turn on the heater,
Close the lid. The LED display shows the actual temperature
of water. When the water reaches the set temperature, it
turns off off indicating that the device is off.
The heater has dual protection. It will be disconnected
automatically after 50 minutes.
3. Press the TIME button to set 15 minutes for the clock.
4. Press the function button to select the degassing function.
The button lights
degassing. After 2 minutes the device switches the mode
for normal cleaning automatically.
16
it blinks.
. Press the On/Off button to start the