Empire Comfort Systems DVCT30CBN95N-2 Installation Instructions Manual page 19

18. Remove barrier screen assembly by lifting the screen
assembly and pulling it toward you. See Figure 16.
Do not handle barrier screen or door assembly with your
bare hands! (ALWAYS WEAR GLOVES)
19. Remove glass door assembly: Using the glass door latch
tool provided, hook onto the latches on the top of the insert
and pry it over the glass door assembly flanges. The top of
the glass door assembly will angle toward you. Simply lift to
remove the glass door assembly. See Figure 17.
41921-0-0420
INSTALLATION (CONT'D)
CAUTION
Figure 16
Figure 17
20. Sync Remote.
Push the sync button to the right of the insert. See Figure 18.
With the batteries already installed in the transmitter, push the
ON button. The receiver will "beep" four times to indicate the
transmitter's command is accepted and sets to the particular
code of that transmitter. The system is now initialized.
• Install liners, logs, and rock wool. See liner and log set
instructions for the proper placement. Placement of the
glowing embers is for a glowing effect based on the look
you desire. Embers look best when placed in layers. Do
not place glowing embers around the pilot assembly.
Place pebbles across the front. Avoid blocking the large
rectangular holes.
BUTTON
Figure 18
SYNC
Page 19